Announcement

Collapse
No announcement yet.

spe reset command

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • spe reset command

    Hello,

    when sending a command with inappropriate parameter count to the SPE2 rev. 1.3 the systems doesn't accept
    new commands like "clear display" e.g. anymore. Is there a software sequence available to "reset" the
    system?

    Markus

  • #2
    Hello Markus,

    To get SPE ready to receive new commands after an inappropriate parameter has been sent, you can send a byte at a time until you get a NAK, then it will work as normal again.

    I hope this helps

    Best regards

    Paul

    Comment

    Working...
    X