Announcement

Collapse
No announcement yet.

Not the right ACK command after "Get Picture"

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Not the right ACK command after "Get Picture"

    Hi There!

    I am using the uCamIII module on a custom board, so far I have been able to communicate and capture an image from the camera. Is there an easy way to preview the serial data being read out of the camera? Just a program that takes a serial read in and will display the image!

    Cheers
    Alexandra

  • #2
    Hi alex,
    Welcome to the forum!

    Have you tried the uCAM-III demo application? Perhaps this might give you an idea.
    You can check for the correct reply of the command and compare it on the data that
    you are receiving.

    For more information, you can also refer to the datasheet.

    I hope this helps.
    Best Regards,
    Kevin

    Comment

    Working...
    X