Announcement

Collapse
No announcement yet.

micro VGA II not responding

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • micro VGA II not responding

    I got three uVGA cards to play with, after switching around GFX and SGC mode
    One of the card got stuck while updating the PMMC file during "erasing module".
    I kepts the the program running for about 30 minutes but nothing happened.
    Then I had to disconnect the card.

    All the other card are working fine.

    This card now does not respond to PMMC loader or in WS3 tool. Is there any way
    to get "factory default" or fix the card?

    I am using CE5 connector

    Regards

  • #2


    Well, loading the original PmmC is the 'Factory default'

    What is the exact message when you try to load a PmmC?

    Does anything appear on an attached display?
    Mark

    Comment


    • #3


      I get device not responding message.
      havent connected the card to a display after the pmmc erase file issue.
      will connect and find out what happened

      regards

      Comment


      • #4


        After connecting the malfunction card to a monitor, the monitor shows NO SIGNAL
        the last working stuff on the VGA card was rundemo, after which i tried to load SGC pmmc file and the transfer got stuck on "erasing module"

        Regards

        Comment


        • #5


          Try reprogramming the PmmC again and see what the message is
          Mark

          Comment


          • #6


            tried to load Pmmc file again
            got Unexpected response from display
            screen shot attached

            Comment


            • #7


              well attachment does not show up

              Comment


              • #8


                after switching around GFX and SGC mode One of the card got stuck while updating the PMMC file during "erasing module".I kepts the the program running for about 30 minutes but nothing happened.
                Then I had to disconnect the card.
                The same thing also happened with me...i have also tried as you did.. but nothing working..

                Now What to do..???

                Help ESPsupport!

                (actually this was happened with me btw)

                Comment


                • #9


                  Get the correct cable, if you are lucky it will all work (actually since you said you get a splash screen I would say you are lucky)
                  Mark

                  Comment


                  • #10


                    i am getting the black screen for some time and screen goes into power saving mode.

                    i am not getting the splash screen(4d system information written ) type....


                    is there any other way to "Boot load" or "Rest to default" type thing available for uVGA other than PmmC??

                    #The other cable also doesn't work...

                    Comment


                    • #11


                      Please refer to answer in your other thread.
                      Mark

                      Comment

                      Working...
                      X