Instructions:
1. Compile the attached ViSi-Genie project and upload it to a uLCD-32PTU (or your target display). Copy the supporting files to a uSD mounted to the PC. Properly unmount the uSD card from the PC and mount it to the uLCD-32PTU.
Note 1.A: Workshop 4 Pro is needed for this code example.
2. Compile the attached sketch and upload the program to an Arduino Uno (or your target Arduino board).
3. Properly connect the Arduino Uno to the uLCD-32PTU. See the application notes for this.
Note 3.A: The sketch uses a software serial port for the display and a hardware serial port to print messages to the serial monitor.
Note 1.A: Workshop 4 Pro is needed for this code example.
2. Compile the attached sketch and upload the program to an Arduino Uno (or your target Arduino board).
3. Properly connect the Arduino Uno to the uLCD-32PTU. See the application notes for this.
Note 3.A: The sketch uses a software serial port for the display and a hardware serial port to print messages to the serial monitor.
If without an Arduino host, you can still run this code example by performing step 1. Then use the GTX tool to send 4 bytes at a time to the display.