Announcement

Collapse
No announcement yet.

4DPi-24-HAT: Back to classic HDMI

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 4DPi-24-HAT: Back to classic HDMI

    So my 4DPi-24-HAT is working just fine, but I am unable to get the image to go through the HDMI port again.

    Deleting
    Code:
    sudo -u pi FRAMEBUFFER=/dev/fb1 startx &
    or simply changing
    Code:
    fb1
    to
    Code:
    fb0
    doesn't change anything: whenever I reboot the Pi, the image goes back to the 4DPi-24-HAT.

    Any way to fix this?

    Also, is it possible to run the image on both the monitor (HDMI) and 4DPi-24-HAT at the same time? Or perhaps on the HDMI alone every time we plug it in?

    Thank you!

  • #2
    Nevermind, of course I found the solution less than 5 minutes later.

    Entering either line in the Terminal will do the job.

    Code:
        
    startx -- -layout TFT
    startx -- -layout HDMI

    Comment

    Working...
    X