help..uoled-96-g2 not responding

[george1]

Hello guys,

just finish programming my Gen4 uLCD_24PTU screens and im very pleased with the resaults.
Now i try to play with the uoled-96-g2 but when i scan the com it does not find it

i use the μUSB-PA5... any ideas what im doing wrong

with this μUSB-PA5 i program successfully my older uLCD_24PTU ...

[george1]

i also tried to connect it using the

• gen4-IB (Interface Board)
• 150mm FFC Cable
• gen4-PA (Programming Adaptor)

i have left from my SK-gen4-24PT but again with no success

[george1]

forgot to make clear that the screen is working and it plays the demo...but i cant find it in the com scan...

[Joseph Herrera]

Hi george1,

You might want to take a look at this forum thread: (it includes checking drivers, connection status, etc)

device is not responding:uOLED-96-G2
http://forum.4dsystems.com.au/forum/...ng-uoled-96-g2

Make sure that the connections are correct as this is a common problem for the OLED..
For proper connections to the uOLED-96-G2, you can refer to this appnote, starting at page 8:

http://www.4dsystems.com.au/download...0041_R_1_0.pdf

Thank you and Regards,

[george1]

no luck with the USB-PA5
but i connect now sucsesfuly using the

• gen4-IB (Interface Board)
• 150mm FFC Cable
• gen4-PA (Programming Adaptor)

i have left from my SK-gen4-24PT... its the same thing i guess...is it???

[Joseph Herrera]

Hi george1,

Yup, for the gen4, you could use either the:
- gen4-IB (interface board), FFC cable, 4D Programmer Cable or uSUB-PA5-II
- gen4-PA (programming adaptor), FFC cable, and micro USB cable

The distinct difference between the two is the number of break out pins. The gen4-PA's break out pins is designed for the GPIO capabilities of the Displays.

For the usual version of the Displays, you could use the 4D Programmer cable or uSUB-PA to program the displays.

Thank you and Regards,