Announcement

Collapse
No announcement yet.

GEN4-ULCD-DT70 USB master

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • pauleilio
    replied
    Hi Sylvain,

    Would it be possible to use the UART or USART I think they are called on you device and connect to the display directly using Tx & Rx or is the USB the only available port to connect to.

    Paul

    Leave a comment:


  • SylvainLAURENT
    replied
    Hi Paul,

    The USB device is an STM32L433CC.. with a USB port using on com port.

    But to use it, it should be connected to a USB master.

    Sylvain.


    Leave a comment:


  • pauleilio
    replied
    Hello,

    Welcome to the forum,

    If you are using the gen4-PA or gen4-UPA then the USB device is a serial port. If using Visi-Genie or Serial SPE the display would be a serial slave. You can use Visi or Designer and then the display can become a serial master by writing your own serial protocol code.

    What is the USB device you want to connect to ?

    Best regards

    Paul

    Leave a comment:


  • SylvainLAURENT
    started a topic GEN4-ULCD-DT70 USB master

    GEN4-ULCD-DT70 USB master

    Hello,

    I'm using an GEN4-ULCD-DT70, and I would connect a USB device on GEN4 USB.

    is it possible to drive this USB port like a master ?

    regards.
Working...
X