I have a 70DT display and a 43PT-AR display. When 4D software is open and display is connected to the USB usin a PA5 adapter, the 43PT can give me a blue dot while the 70DT gives me a red dot and device not recognized. Any solutions? Thanks for any help.
Announcement
Collapse
No announcement yet.
Display not recognizing Comm ports
Collapse
X
-
Hi,
Thanks for that. So we know that this isn't likely to be a power issue. Comms to the display can sometimes be affected if there is something else connected to the display on the Tx, Rx.
Is it is the same PA5 adapter that you are using for the 43PT display ?.
When you check for comms do you notice the screen reset an restart after you press the button.
Best regards
Paul
Comment
-
I use the same PA5 for both displays I just set up the display and 4D workshop plugging in the USB cable to a different USB port on the PC and I got a blue dot!!
I don't have time right now to load my display but will try later. Thanks for the reply as I would not have stumbled on to this scenario
Joe Berki
Comment
Comment