Announcement

Collapse
No announcement yet.

Issue with output from Programming cable to UwTerminalX

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Issue with output from Programming cable to UwTerminalX

    I have just downloaded and installed the corresponding drivers for the 4D programming cable(CP210x). I am using UwTerminalX to read my serial port connection and output the stream of data. However, when I link my cable up to a device, and use UwTerminalX to output this stream of data, instead of coherent data I am getting symbols. Is there any further configuration needed on this cable?

    Any help would be greatly appreciated,

    Thanks.

  • #2
    Hi Fudgey,

    Welcome to the forum.

    Does the baud rate of the device you connected on the programming cable is the same with the settings on UwTerminalX?

    Regards,
    Ferdinand

    Comment

    Working...
    X